Click image to view full size image
CUMSA Precision Injection Mould Fan Gate For Blade Wheel
Quick Detail:
1. Standard of mold accessories: LKM, DME, HASCO, MISUMI, Meusburger, CUMSA, Progressive, INCORE, HRS, Husky, YUDO, PETS, MOLD-MASTER, MERKLE, Parker, HPS, EUCHNER, RJG, cilpres, NITTO, CRACK, ASSAB, GSW DIN standard, BOHLER, AISI standard, DAIDO JIS standard, PUNCH etc according to our customers requires.
2. Plastic material: PA
3. Cavity material: H13 HRC48-52
4. Mold life: 1000k shots or according to customers quantity condition to decide it with saving cost for our customers.
5. Gate type: Point-gate, direct gate, fan gate, point gate, edge gate, valve gate, tip gate etc according to our customers requires.
6. Mold base standard: LKM Local standard, DME or HASCO, Customize according to customers' requirements.
7. The part name: Blade wheel(plastic injection mold)
Description:
The part name: Blade wheel
Mold type: Plastic Injection Mould with cold runner system
Part Material: PA
Locating ring Dimension: 100
KO Pattern: 200*200
Sprue Radius: SR 19
Ejection type: ejection pins.
Mold construction description: cold runner system with point gate, 2 plates, there are many ribs in the product, which weight is very accurate, so many size tolerances are no more than +/-0.02mm. the finish surface of those ribs must meet mirror surface and can not have any deformation.
This part has very high appearance and size requirements, the defect showed below will not be acceptable, for example, weld line, Dark Sport, Sliver Marks, Gas Trap Effect, Visible Ejector Marks,Deformation,Short shot Filling, Burnt Streaks, Sink Marks,Flash,Over dimension, Under dimension, Stress Crack etc. Moreover, the product finishing surface must meet the requires more than SPI-SPE A-2.
This mould is made in Shiny Mould Factory. It is a mould exported to Europe, with complicated structures and high quality requests. Customer needs mold life to be over 1 million shots. We can ensure this mold life and give warrant to our customer that once some mould components are broken during working, if it is caused not by the operation fault from the workers, we can provide new mould components to them free of charge.
Specifications:
